Modifications

JCW Strut Brace

Preparation

Remove the three bolts on both sides using a 13mm Socket.

Align the bracket and tighten the three nuts on each side by hand so make sure they go through the holes, wiggle the brackets to make sure they seat and align correctly and then tighten to 35Nm using a torque wrench.

Get the middle bar to lay evenly on the air box (it can be rotated back and forth) then tighten the bolts using a 7mm Allen Key and 17mm Ring Spanner then tighten the nuts at both ends with a 17mm Open Ended Spanner.

Job Done

[T O P]

Page creation 21st August 2006 © 2008 GameStone
All trademarks and copyrighted material are the property of their respective owners